SS.Montr Set Status
From NitrOS-9
Revision as of 16:26, 5 April 2014 by Glaw16 (Talk | contribs) (Created page with 'Sets the monitor type. {| | colspan="2" | '''Entry Conditions''' |- | A || ''path number'' |- | B || SS.Montr ($92) |- | X || ''monitor type'' |- | || 0 = color composite…')
Sets the monitor type.
| Entry Conditions | |
| A | path number |
| B | SS.Montr ($92) |
| X | monitor type |
| 0 = color composite | |
| 1 = analog RGB | |
| 2 = monochrome composite | |
| Error Output | |
| CC | carry set on error |
| B | error code |
Additional Information
- SS.Montr loads the hardware palette registers with the codes for the default color set for three types of monitors. The system default initializes the palette for a composite color monitor.
- The monochrome mode removes color information from the signal sent to a monitor.
- When a composite monitor is in use, a conversion table maps colors from RGB color numbers. In RGB and monochrome modes, the system uses the RGB color numbers directly.
- The support modules for this call are VDGInt and GrfDrv.
